Wet Area Silicone

Use in a well ventilated area. Avoid contact with skin and eyes.

1. Clean surface with mineral turpentine and dry.
2. Cut cartridge, fit and cut nozzle at 45° angle and fit into a caulking gun.
3. Apply with steady pressure, ensuring sealant is pushed into joint.
4. Tool with a spatula dipped in detergent water within 5-10 mins of application.
5. Clean up with mineral turpentine before product skins.
6. Sealant will cure in 72hrs.

Limitations:

• Not paintable. Complete painting 7 days prior to applying sealant.
• Not suitable for building materials that bleed oils or solvents, such as impregnated wood.
• Not for use on polyethylene, polypropylene or Teflon. Pre-test plastics before use.
• Not suitable for aquariums.
• Not suitable for food or drinking water contact.
• Not suitable for permanent water immersion.

• For neater joints, mask sides before applying sealant and remove tape before sealant skins.
• When first applying product, extrude a small amount onto a piece of scrap material to ensure a smooth continuous flow of silicone sealant.
• Work in sections that can be completed before sealant skins.
• Tooling off and tape removal must be completed before skinning occurs or a rough surface, may result so working in sections allows for a better finish.

Refer to product label for full conditions. This guarantee does not limit and may not necessarily exceed your rights under the Competition and Consumer Act 2010.

• Uncured product may be removed with mineral turps.
• Cured product can be removed with Selleys Silicone Remover or by
  cutting and scraping.